Epson T0321/T0322/T0323/T0324/T0422/T0423/T0424 Refill Instruction

1. Reset the microchip on the cartridge first.

2. Put the cartridge on some paper towels in an area where you can tolerate a spill.

3. There is a flat area about 10 mm. width on the tup of the cartridge, in front of the label.

    Use an awl to drill two holes on the flat top, one for filling and another for vent (See diagram).

    The centers of the holes are located about 5 mm away from left side.

     For the color cartridge, do not drill deeper then 12 mm, otherwise you may destroy the inside baffle.

4. Fill the syringe with correct ink.

    Very SLOWLY inject up to 25 ml of black ink or 10 ml. of color ink for each color.

5. A little ink might come out once full. In that case, stop filling right away and withdraw 1 ml. ink.

6. When finished, use silicon or tap to seal both holes. Install the cartridge and make a test print.

7. Clean the syringe with water and dry for future use.

* For the color cartridge, suggest refilling sequence Yellow > Magenta > Cyan.

  Clean the syringe with water and shake several times to let residual water out before different color refilling.

* Refill immediately once cartridge empty.